Pages: 1
Hey all.
I'm new to this forum but so far I can see that there is some very talented people in here.
As the subject says I am planning on casting a silver bullet its going to be a .45 bullet made from solid sterling silver.
I am not yet sure if I want to make a necklace out of it or just make it into some kind of charm.
Naturally I will make sure to take a lof of pictures of the process and put them up here when I'm done making it. But before I do I would love a little help from you talented people out there.
The plan is to cast a bullet complete with casing. On the casing I want to create a nice floral pattern featuring the Aconitum (wolf's bane) flower but I am no good at drawing this on the bullet.
If you are interested in helping me I have found a picture of a .45 bullet http://en.wikipedia.org/wiki/File:.45_ACP.jpg it should be easy to remove the measurements and lines in paint. it should preferably not be to detailed since the casting will go wront if it is.
I hope one of you will help me out.
Sincerely Henrik Poulsen
Offline
Pages: 1